This article will talk you through how to connect a Project EV EVA-07S-SE charger to the Clenergy EV back office.
Older Project EV firmware only allows the charge point to connect via a non-secure websocket (ws://clenergy.online:8082). Newer firmware allows the charge point to connect via our secure websocket (wss://clenergy.online:8081).
Please check with Project EV as to whether the unit require a firmware update prior to onboarding to our back office. They will request that you point the unit to their server to be updated.
- Connect your laptop/PC to the RJ45 port via the removable panel on the left hand side of the charger. Set your laptop/PC to the IP address: 192.168.1.xxx and the Subnet Mask to 255.255.255.0. Please note: x can be any value between 1 and 255, except 5.
- Open your web browser and enter the following URL in the search bar: 192.168.1.5:8080.
- Once the portal has loaded, enter the following password: 12345678; then select Submit.
- Configure the network settings as required for your installation using the relevant fields, then enter the following URL into the Server URL(MaxLen 250) field: wss://clenergy.online:8081.
If using the 4G/SIM method of network connection, enter the relevant details into the APN, User Name and Password fields.
Please note: If using a Clenergy EV-supplied SIM card for the network connection please refer to the details below.
Conexa SIM APN: eapn1.net
KPN SIM APN: wlapn.com
Password/Username (for both suppliers): clenergy
In the event a 3rd party SIM card is being used, please refer to the supplier or manufacturer for the correct details.
Use the PIN provided with the SIM card.
- Scroll down to the bottom of the page and select Set and Reboot.
- Select OK when prompted to complete the onboarding process.
